How do Water Well Drilling Rigs Operate?

 Water well drilling rigs is a top-drive, multi-functional, full-hydraulic drilling rig with advanced technology, convenient use, high operating efficiency, reliability, and durability. It is widely used in drilling water wells, detection wells, dewatering wells, rescue wells, and ground wells. Source air conditioning holes, coal-bed methane, natural gas, oil extraction, and other projects are suitable for various drilling techniques and various drilling tools, with convenient and flexible control, fast drilling speed, and short time, so the operation efficiency is high.

1. Connect the drill bit and drill pipe under the water well drilling rigs host, and start the gasoline engine (use it according to the gasoline engine manual).

1. The water pump delivers water. The soil loosened by the drill bit of the water well drilling machine is flushed out at any time, flows through the sedimentation tank, and flows into the mud tank.

2. When drilling a soil layer with a water well drilling machine, clean water is effective; but when drilling a sand layer, mud water must be used. The thicker the mud is when the pump can be pumped. The thick mud is good for dragging out a lot of sand.

3. Water well drilling rigs After drilling the drill pipe, do not lift it immediately, make it continue to supply water, rotate it, and move the drill pipe back and forth in the hole. On the one hand, the well wall is made smoother, and on the other hand, as much sand as possible is flushed out of the wellhead.

4. Lift the water well drilling rigs properly, unload the drill pipe, and then lift the main engine head to the upper end, connect the new drill pipe, and continue drilling. Until the ideal high level.

5. In the process of drilling with a water well drilling machine, pay attention to the high level of the sand layer. Because the sand layer has a large water content, a part of the water pipe should be drilled in the sand layer at the lower end of the water pipe. If the drilled part is in the mud layer, it will affect the water quality.

6. After drilling with the water well drilling machine, move the main machine head to the inside of the frame, and use the fixed pulley to directly and quickly lift the drill rod section by section.

7. For drill pipe with a diameter of 28, it is recommended that the opening diameter is within 120 mm, and the high-level depth record is 98 meters (different soil quality and water pump have different effects). The recommended hole diameter of 34 drill pipe is 160 mm, and the height is about 30 meters.